Shield clamp made of spring steel for terminating cable shields on busbars — stamped and formed part for EMC shield bonding in control cabinets · Biegema

Electronics

Shield clamp / EMC shield clip

U-shaped spring clamp for EMC-compliant shield termination: the exposed cable shield is pressed into the clamp and held against a busbar, DIN rail or mounting plate with constant spring force over a large contact area — maintenance-free, vibration-proof, with low-impedance dissipation of high-frequency interference currents.

Material: Spring steel 1.4310 · 1.0 mm

Production

Can be produced on these machines

FMS-Q 120 RS

Eine Maschine, viele Aufgaben

CYCLE 500 T/min
PUNCH 80 kN
BEND 12/22 kN

Go to machine →

FMS-Q 250 RS

Power with high performance.

CYCLE 400 T/min
PUNCH 250 kN
BEND 30/50 kN

Go to machine →

FAQ

Häufige Fragen zur Fertigung: Shield clamp / EMC shield clip

You can produce Shield clamp / EMC shield clip on the FMS-Q 120 RS and FMS-Q 250 RS. The FMS-Q 120 RS works with 80 kN punching force, strip material up to 50 mm width, wire up to 4 mm. At up to 500 parts per minute, the machine is designed for series production — finished parts come straight off the machine.

The radial design positions the bending slides freely through 360° around the central bending core — ideal for parts like Shield clamp with multiple bends in different directions. Tool changes take less than 30 minutes, so even smaller batches are economical.

Spring steel 1.4310 (1.0 mm) runs through the punch-bending machine as strip or wire stock in a progressive process: punching, bending, and inspection happen in one pass. Instead of buying parts from suppliers, you produce them in-house at significantly lower unit costs from medium quantities upwards — Biegema configures the machine specifically for your part.