Which machine suits your part?
Upload a photo, describe your project or select an example. Our system suggests the right solution, and we will call you back today so you receive individual advice.
- 1 Upload a photo, select an example or describe your project.
- 2 You receive an initial machine recommendation and feasibility assessment.
- 3 Start a no-obligation inquiry and talk directly to the engineer.
Analyzing your project — typically 3-5 seconds …
Note: The AI provides non-binding suggestions and initial guidance. Information may contain errors and does not replace personal consultation. For an individual recommendation, please arrange a consultation.
Personal consultation is the way forward here
Send inquiry
Your selection is already saved. Just add your contact details — we will get back to you within 1-2 working days.
All manufacturing examples
Three series. One logic: the right kinematics for your part.
Radial, linear, modular. We choose the design that produces your geometry most economically.
-
FMS-Q RS
Radial Series
- 80 RS
- 120 RS
- 250 RS
- 350 RS
- 700 RS
-
FMS-Q L
Linear Series
- FMS-Q 700 L
- FMS-Q 250 L
-
BMS
Modular Series
- BMS 5
A 360° tool arrangement. Full freedom for complex forming on a minimal footprint.
Radial Series
Short lines of communication. Directly to the engineer.
We are a family business in the Black Forest — not a sales funnel. You call and speak directly with the engineer who built your punch-bending machine.
“With us, there are no tickets and no waiting times. You call and speak directly to the person who built your machine.”
Our engineering team is ready to help.
Mon – Fri · 8 am – 5 pm
Stamping and Bending Machines Engineered in Wehr.
We have been developing and building punch-bending machines in the Black Forest since 1979. Straight from the engineer, without sales cascades. Four promises you can hold us to:
48-hour concept response
Send us your drawing — we reply with a concept, tool sketch, and cost-effectiveness calculation within two working days.
Tool change in under 30 minutes
Our quick-change system reduces setup times by up to 80% compared to conventional tool solutions.
30+ years machine life
FMS-Q systems from the 1990s are still in production today. We guarantee spare parts, even after decades.
Straight from the engineer
You speak with engineering, not with sales. Engineering to engineering, without detours.
Frequently asked questions about punch-bending machines
Spring steel, stainless steel V2A/V4A, copper, brass, spring bronze, aluminum, and galvanized steel. Depending on the model, up to 4.0 mm material thickness and 60 mm strip width. For wire bending, diameters up to 8 mm are possible.
With our quick-change system, operators typically change tools in under 30 minutes. This is significantly faster than with conventional punch-bending machines. A complete changeover cycle (tool, material strip, test run) takes about one hour.
Rule of thumb: 80 kN for contact springs up to 1.5 mm, 250 kN for spring steel up to 2.5 mm, 700 kN for 2 mm copper busbars and bearing steel. We provide the exact calculation free of charge in our concept within 48 hours.
Yes. With defined response times (24h, 48h, best-effort), spare parts stocking in Wehr, and remote maintenance via VPN.
We develop and manufacture every machine in Wehr in the Black Forest, Baden-Württemberg. Made in Germany, 100 percent.
Managing Director Stefan Wagner and the engineering team. You speak directly with engineering, without a sales pre-meeting.
Let's talk about your requirements. We provide expert advice.
- ADDRESS Finsterbachstr. 13 , 79664 Wehr , Deutschland
- PHONE +49 (0) 77 62 / 52 12-50
- EMAIL info@biegema.de
- OPEN Mon – Fri · 8 am – 5 pm